Transmission gear light

[Turbo6Smackdown]

Ok, I heard this isn't a light bulb, but part of a printed circuit board. So how I get my light working again?
And does anyone know what kind of bulb goes in the glove compartment? The internet says it's a bayonet style bulb but I sware my bulb socket doesn't look like a bayonet style socket. It looks like it's a push in type. Anyone?

 

[TLIMITED]

The shifter indicator is a bulb,Sould be the same as marker light(push in style).194 bulb

 

[Turbo6Smackdown]

Sweet. Thank you.

 

[JimP]

Get the led equivalent it looks much better illuminated only a few bucks.

 

[Turbo6Smackdown]

Does it last? I converted all my interior lights in my GS to leds, and they ALL burned out within 6 months...

 

[JimP]

That's odd, mine have lasted, changed all my interior lights in my DD Impala, been going on three years, recently did the GN and no issues. I don't remember which brand of l.e.d. I used but it was a local guy, was a bit more expensive than buying on line but he said they are good quality.

 

[Turbo6Smackdown]

I see. Gotta do more research then. Thank you.

 

[precizion818]

I used superbrightleds.com for mine. Tried buying the cheap LEDs off eBay and they did not last or wasn't bright enough.


Posted from the TurboBuick.Com mobile app

 

[Turbo6Smackdown]

That's where I got mine for the GS. They were all tits up inside of 6 months. Every single one of them.

 

[JimP]

I pulled a couple of the l.e.d.'s out to see what brand they were. "Phillips" like I said none have burned out been close to three years.

 

[garyk1970]

Fyi, if you have problems with bulbs or leds going out, double check to make sure your alternator isnt overcharging.....also on the trans shift indicator lamp, it grounds with a simple clip on the shifter bracket, make sure it isnt loose...

 

[rev. 3:11]

X2 on superbrightleds
I swapped ALL my interior lights to LEDs (dome, map,footwell, trunk, AVC dash cluster & even the "junkyard" lighted mirror I added)
Glove box lite is a 194/168S push-in type, my glove box switch is flaky
I used the "cold" white single LEDs & they really light up much better
I used a red 1 LED bulb in the shifter & can see it in the daylight even!
None have burned out in 2-3 years, so far...
(although I did receive a couple of defective ones)
Thinking about putting rope/ribbon lights in trunk & under hood, they can be mounted discreetly
& give a lot of illumination & use just an itty-bitty amount power

D

 

[Heisenberg]

X2 on superbrightleds
I swapped ALL my interior lights to LEDs (dome, map,footwell, trunk, AVC dash cluster & even the "junkyard" lighted mirror I added)
Glove box lite is a 194/168S push-in type, my glove box switch is flaky
I used the "cold" white single LEDs & they really light up much better
I used a red 1 LED bulb in the shifter & can see it in the daylight even!
None have burned out in 2-3 years, so far...
(although I did receive a couple of defective ones)
Thinking about putting rope/ribbon lights in trunk & under hood, they can be mounted discreetly
& give a lot of illumination & use just an itty-bitty amount power

D

Like this?

 

[Turbo6Smackdown]

I will check