ok,im new to the GN world. car ran fine i pulled it out and washed it,a little later i went to leave and service engine light comes on and scanmaster was blank.i limp it back into the garage and start trying to figure it out.
i pulled the ecm and it had a little bit of water on it (i has justed washed the car) i took it apart a blew in out with a air hose. again only has small amout of moisture. anyway turn ignition on and scanmaster now has 6 dashes
on screen,if a hit the alky test button car will crank with (no service engine light on )for a few seconds then cut off. any ideas where to start i do not have another ecm to try could it have messed up the ecm
i pulled the ecm and it had a little bit of water on it (i has justed washed the car) i took it apart a blew in out with a air hose. again only has small amout of moisture. anyway turn ignition on and scanmaster now has 6 dashes
on screen,if a hit the alky test button car will crank with (no service engine light on )for a few seconds then cut off. any ideas where to start i do not have another ecm to try could it have messed up the ecm
