Recent content by postal

"This works for a 9 bolt? It says 10 bolt. Thanks" Hmmm I wasn't aware of this. I purchased it to put on when bought my Moser 9" rear end. I actually had a problem trying to put this on the 9". The big torque arm adapter was to thick and bulky and I had to modify the t-arm to use it with my...

I bought the rolling chasis this motor cam out of. This motor sounded good, ran good, didn't smoke, made good power ect ect.. I helped pulled the motor out of the car and put it on the stand. Nice motor tight motor guys! Jason

Its a siam. bore 4.1 that was ran at just over 3.8" bore. It had insanely thick cylinder walls and now it looks like it has extra thick cylinder walls. This block went from Roger Davis to me, then from me to Craig. Its a real nice looking block and it has alot of meat in it. You can rebuild...

Edelbrock Torque Arms: EDL-5280 - summitracing.com You may want to look at one of these if you're on a budget. I ran one of these and it seamed to work real good for me. I sixty footed in the low 1.5's to mid 1.4's with a relatively low dollar rear suspension. I got the above bar brand new...

Same set up but with a non ball bearing 63, went 11.16 and 11.17 back to back hot lapped with 3 pound launch through the full exhaust. Not too bad for a bone stock 104,000 mile long block. Jason

Quiky One: I dont have any pics of my set up. I'ts a bad habbit of mine not to take pics. I wish I did have some pics because I probably had the most hardcore looking stock long block out there. I had a good bit of braided lines because I had a pretty wildly modded fuel rail with big lines...

Dan Strezo at DLS would be a good guy to talk to about whats available. Jason

"Melissa has the "flapper" in her car .. she has gone 10.10" Well Grumpy its looks like Melissa and her "Flapper" are doing well, so thats nice to hear, I'll sleep much better now. The thing I would like to ask is WTF does that have to do with the question of: "How hard is it to...

"Is there any reason why I couldn't use a TH elbow from a GN if I just used the flange and cut off the bend and remade it? " you would be destroying a pipe you could sell for good money just to get a flange and puck. I dont think you would wind up using enough of the Houston pipe to come out...

Denny: Before I got too far into anything I would take a serious gut check on what you want to do. The faster cars tear stuff up, and constantly have to be maintained and tweaked to keep them running right and to keep them together. I know you’re not a grease monkey like Mike, Prasad, Surej...

Steve: Liquids are cool set ups and can do some crazy stuff. My Buddy Roger was seeing some insanely low mats at the end of 150+ mph runs in his metro. If I remember correctly his Mats where in the low 40 degree range at the end of the track over in Indy in june. He has alot less money in...

Well stupid an external waste gate is simple you just have to be smart enough to realize it. Jason

ATR made me an external gate down pipe that was set up for a Turbonetics deltagate. It was quicker and easier to adjust the boost than any puck style set up I've ver been around. I had a T-netics dial a boost set up hooked up to it and I could set the boost from 10# to 30# with a simple turn of...

PM sent Jason

Can you give me a model number for the FP regulator so I can look it up. If its right for my application I'll probably take it. Jason