2 step issue

[ITSAV6]

Hooked it up this afternoon and it cranks up and dies about 1 or 2 seconds later. I double checked the signal wires(white to ecm). Confused on the fuse adapter, does it have to go a certain way?

 

[pacecarta]

yes it has to go as instructed , as i recall the fuse must be facing down (manual reads wires to the right )
you must replace the old fuse into the fuse holder

dont forget the ground

and you must set the config dips to ....config 3 off /config 2 off/ config 1 on

 

[ITSAV6]

I believe the fuse is up. Maybe that's it. Thanks

 

[ITSAV6]

hooked it back up and it acts like its on 2 step all the time. Gonna check dip switches again

 

[ITSAV6]

Dip switches set correctly. Tried reversing the connections at B4 and it just cuts off after it cranks.

 

[pacecarta]

a

 

[ITSAV6]

Don't know how they are supposed to be at the box

 

[TurboBob]

whats the serial number on the unit? Its on the sticker inside.

Bob

 

[ITSAV6]

think its 241

 

[larrym]

I supplied this to the OP I had a couple issues when I first set it up, I had to use a GM module.
After that I had no problems I have since gone to a TR6 module with LS coils If there are problems and you can't get it working properly let me know maybe Bob needs to take a look at it if so I will share in the expense or take it back.
It has been update to the most current flash on the bailey site.

 

[TurboBob]

there is a new flash file that may help the false triggering. hit me up on email and I can send you the update.

I should also update the support web page.

Bob

 

[ITSAV6]

I supplied this to the OP I had a couple issues when I first set it up, I had to use a GM module.
After that I had no problems I have since gone to a TR6 module with LS coils If there are problems and you can't get it working properly let me know maybe Bob needs to take a look at it if so I will share in the expense or take it back.
It has been update to the most current flash on the bailey site.

Now thats a stand up man there! If the update doesnt fix the issue I'll just sell it and go TR6

 

[TurboBob]

pm me your email

 

[ITSAV6]

my lame azz computer won't let me open the files. I'll try my sons computer tomorrow.

 

[ITSAV6]

I have a GM icm now and it starts and goes dead. Reversing the connections on ecm wire and it acts like it's cutting out at idle. Sent u a pm Bob

 

[pacecarta]

did you somehow get the power connector at the 2step reversed ? they were reversed on first batch

 

[TurboBuRick]

Anti theft chip?

 

[ITSAV6]

I do have anti theft but I have the feature turned off. I don't think the power is reversed. What's the order of the plug on the unit?

 

[pacecarta]

 

[ITSAV6]

Thats how my plug looks.