3 inch high flow catalytic converter

["Turbo-T"]

Looking to see if anyone has one they want to part with. New used, whatever....as long as it's a high flow and (obviously) not gutted. Pics with priced shipped to zip 65305. Thanks.

 

[3.8L V-8 eater]

I have a nice stainless one, but it has a v-band flange on it..You would have to have a V-B flange on the end of the down pipe to bolt it up..Does make it easier to take off and on with this flange however.....

 

[wickedtt]

I have a brand New one thatcame with my SS THDP from years ago..

 

[bdasv6]

I have 2

 

["Turbo-T"]

I have 2

How much are you asking shipped to 65305, how many miles on them (if any) and do you have any good pics?

 

[MaxVO2]

I have mine, which was only bolted to get to the Emissions station and then taken off - probably no more than 30 miles total on it. It has the correct flange, is high flow, etc.. $105 shipped to 65305. The welded overall length is 14.5 inches and with the extra section (removable) it is 18.5 inches. The extra section allowed for different length downpipes and exhaust setups on my two GN's, and to make it easier to remove. My car has historic tags now so no more testing on it (thank goodness...) in Maryland.

The GN in the pic is not to scale. The convertor will look different bolted on to your car!

Billy

 

["Turbo-T"]

Anyone else have a 3" hi flow cat they're selling? Preferably low miles

 

[49-blues]

I have a brand new one-$135. Shipped

 

[Onalky87]

Pm sent.

 

[turbo89]

I have a brand new one $100 shipped

 

[TurboBuick86]

I have one for sale. Asking $125 plus shipping it's in very good condition.

 

["Turbo-T"]

Pm sent.

Sent PM back, a/w photos

 

["Turbo-T"]

Never received response, anyone else have one they want to sell?

 

[MaxVO2]

Still have mine for $105 shipped. I can ship it out tomorrow if needed, and I will respond.


Billy

 

["Turbo-T"]

Still have mine for $105 shipped. I can ship it out tomorrow if needed, and I will respond.


Billy

Sent you a PM

 

[MaxVO2]

Pics of inside convertor as Turbo-T requested.

 

["Turbo-T"]

Thanx Billy, sent you a 2nd PM.