adj pushrod length checker

[WE287GN]

Where can i get one

i see here in Jeggs , have for 5/16 sbc and a 5/16
BB buick and some others BB's

wich one should i get ,or is there somewhere better to get one

this particular set was from Crane.

thanks bunch

Chris Pacheco
P.S. i dont think i will be needing to go anything shorter than maybe .030 -.050" under stock on pushrods

 

[Nashty]

Powerhouse products is where I got mine. (Comp cams) I needed one in the range around 8.4", they go in inch increments.

 

[WE287GN]

thanks

most likely wil order from jeggs or summit

wondering if it matters or not BB sb ,engine make,the adds i have seen to not mention buick v6

the most i know is the 3.8 uses 5/16 diameter pushrod right??

thanks

chris pacheco

 

[HYPER-6]

Originally posted by WE287GN
thanks

most likely wil order from jeggs or summit

wondering if it matters or not BB sb ,engine make,the adds i have seen to not mention buick v6

the most i know is the 3.8 uses 5/16 diameter pushrod right??

thanks

chris pacheco

You have mail.

 

[WE287GN]

Originally posted by HYPER-6
You have mail.

hi hyper,didnt recieve any mail

thanks
Chris

 

[WE287GN]

DO any of the Buick vendors carry these???

 

[HYPER-6]

Originally posted by WE287GN
hi hyper,didnt recieve any mail

thanks
Chris

Chris:

I just resent it. www.powerhouseproducts.com
Part #POW101220 (if you're running a flat-tappet cam).
$16.95.

 

[Nashty]

One other important thing!

Check your pushrod length THEN add .030" for preload when ordering.

Don't forget to add for preload - especially if you have a non-adjustable valvetrain!

 

[Scott231]

Chris - you can borrow mine to get your motor setup. Send me a Private Message if interested.

 

[Nashty]

It doesn't matter what the application (Ford, Chevy, Buick...)

My car has Powerhouse one piece 5/16 prods that are listed for a Ford application on it.

A pushrod is a pushrod, the end diameter is the determining factor.

 

[WE287GN]

thanks guys

thanks everyone
Nashty i ended up ordering the one from powerhouse

Scott, thank you very much for extending that offer,very kind of you
i can wait though, i am doing my tranny over (with the help of the guys in trans talk), and cleaning up engine bay, in the mean time

thanks again
Chris Pacheco

anyone feels like taking a stab at a head re-torrque question,i'll ttt my post, couple questions i had about the procedure