TURBOPOWERED68
David
- Joined
- Jan 31, 2006
- Messages
- 8,819
I have been putzing around the idea of another build and would like to pay for it with as much of my current stuff as possible.
If this looks promising i would post it in the forsale section using this list as first in line.
at this point NOTHING is for sale YET.
1- 11k miles short block with 20 over trw forged, stock rods, stock crank i think std/std
2- Stock Iron heads with bigger valves --RPE did the Valve work and springs for a roller cam, bowl work and a little clean up by someone else ????.
3- HR 1.65 Roller Rockers a few months old, had to grind them to make them fit- about 300 miles on them.
4- 206/206 billet webber roller cam with hardware.
5- Morell roller lifters
6- Roll Master timing chain
7- Timing cover - not an Earl unit but works great
8- Stock lower intake manifold
9- Stock Throttle body Ported to 62mm with matching plenum by Steve Monroe
10- RJC Power Plate for stock plenum and intake
11- Scanmaster with PL update ---- $190.00
12- PowerLogger
13- BB 2-Step with brake pedal switch
14- Coil and Module -- on car working.
15- MSD 8mm red wires
16- Hacked up engine harness, replaced ECM, Maf plugs and shortened --its working great so far.
17- Stock intercooler fan
18- Stock intercooler
19- Stock MAF sensor - Working
20- Power steering pump and reserve with backwards thread cap
21- Accessory bracket -- Welded 7 years ago works great.
22- Ac Delete pulley with bracket
23- Aluminum plenum Spacer 1 inch with some Vacuums on it.
24- Adjustable fuel pressure regulator
25- Volt Booster Reds
26- Ask for other under the hood stuff that i might have forgotten.
If this looks promising i would post it in the forsale section using this list as first in line.
at this point NOTHING is for sale YET.
1- 11k miles short block with 20 over trw forged, stock rods, stock crank i think std/std
2- Stock Iron heads with bigger valves --RPE did the Valve work and springs for a roller cam, bowl work and a little clean up by someone else ????.
3- HR 1.65 Roller Rockers a few months old, had to grind them to make them fit- about 300 miles on them.
4- 206/206 billet webber roller cam with hardware.
5- Morell roller lifters
6- Roll Master timing chain
7- Timing cover - not an Earl unit but works great
8- Stock lower intake manifold
9- Stock Throttle body Ported to 62mm with matching plenum by Steve Monroe
10- RJC Power Plate for stock plenum and intake
11- Scanmaster with PL update ---- $190.00
12- PowerLogger
13- BB 2-Step with brake pedal switch
14- Coil and Module -- on car working.
15- MSD 8mm red wires
16- Hacked up engine harness, replaced ECM, Maf plugs and shortened --its working great so far.
17- Stock intercooler fan
18- Stock intercooler
19- Stock MAF sensor - Working
20- Power steering pump and reserve with backwards thread cap
21- Accessory bracket -- Welded 7 years ago works great.
22- Ac Delete pulley with bracket
23- Aluminum plenum Spacer 1 inch with some Vacuums on it.
24- Adjustable fuel pressure regulator
25- Volt Booster Reds
26- Ask for other under the hood stuff that i might have forgotten.
Last edited:
