Anyone want the high performance bearing numbers and vendor info?

[Intercooler]

Got you looking!


Actually I pick up my motor in about 2 hrs. so I will have the Durabond Teflon coated cam bearing box and also the "H" series main and rod boxes from Federal Mogul with part numbers. I will ask him for the vendor info too while there so keep an eye on this thread if you are near this point.

 

[Butch]

We don't need no stinking bearings! My car only has 119k miles on it. It will be another 15 years before I need new bearings. Unless, of course, I install the MSD 50's, and the PTE-54, and the Front mount that I have sitting here. Then I may need more than bearings

Actually, I wish someone would put together a "diary" of engine rebuilds. Kinda like what they are doing in GM Hitech mag.


Butch

 

[Intercooler]

Ok,

Doing this too for myself in case I lose these but never can tell because the archives may get purged again.

Rods- Speed Pro/Federal Mogul
Part # 6-7120 CH 10 The 10 at the end is .010" and these are "H" series, rolled edge and a little wider than stock bearings.

Mains- Speed Pro/Federal Mogul
Part # 107M 10 The 10 at the end is .010" under and these are "H" series bearings.

Cam- Durabond
Part # BP-13T The "T" at the end is for Teflon coated. They are black on the inside surface (Teflon) just like the new Speed Pro/Federal Mogul Teflon coated piston skirts.


All of these can be gotten from PBT and they are the finest high performance bearings that can be bought for our motors.