Im in the process of rebuilding the front end on my GN. I was able to break all the tie rods loose, and the upper ball joint popped out easily. The lower balljoint will NOT separate from the lower front conrtol arm. I tried hammering the hell outta the lower arm, and even on the spindle. I have a large pry bar that I tried to use too.
Any suggestions to break the lower ball joints loose?
p.s. The upper ball joint and the tie rod ends are still connected, just loose. I haven taken the bolts all the way out yet until I break the lower ball joint loose.
Any suggestions to break the lower ball joints loose?
p.s. The upper ball joint and the tie rod ends are still connected, just loose. I haven taken the bolts all the way out yet until I break the lower ball joint loose.