car stalls

[ricturbo]

when I first press gas it stalls alittle and while driven it stalls when I let off gas . I put new tps and iac on car tbs .41 . do I need to set iac torx screw? ser engine light went out when I installed new sensors.

 

[ricturbo]

Anyone have a suggestion on what I need to do to stop throttle hesitation?? when I give gas and let off of gas..

 

[ricturbo]

Well I was hoping someone had a solution for the problem . I turned torx screw till one thread showing like 1 thread said , and ran car for 1 min and started back still stalled when gave it gas. I read some thread on how to reset iac but didn't understand I have a multimeter , is there a way to set iac with that??, or would iac even make it stall

 

[1fastcobra]

Buy a scanmaster.
Best tool u can have.
U may have another problem
Not throwing a code. U can see it with a scanmaster.

Posted from the TurboBuick.Com mobile app

 

[ricturbo]

I was

Buy a scanmaster.
Best tool u can have.
U may have another problem
Not throwing a code. U can see it with a scanmaster.

Posted from the TurboBuick.Com mobile app

I was planning on driven this car daily , are they reliable , or am I going to be working on car daily ??

 

[1fastcobra]

I was
I was planning on driven this car daily , are they reliable , or am I going to be working on car daily ??

You will get a diff answer from everyone
Too me. As a daily driver. No! !


Posted from the TurboBuick.Com mobile app

 

[notacarlo]

Daily drove mine for 5 years with no issue.

Sent from my SPH-L720 using Tapatalk 4

 

[hiboom]

I think it's like any 26 year old car. you drive it you'll work on it, especially if you run it hard. I used mine for a 120 mile commute for two years when i first got it never left me stranded but still add issues I had to address to keep it going 86-87 computor cars were just in the infant stage so a lot have progressed what help me was to have two of every thing and the tools and ability to diagnose and keep running it is a labor of love for these cars.yes they can be made dependable.I would be more worried about were i had to leave the car everyday without it getting stolen.

 

[ricturbo]

what about the stalling any ideals??? just fixed the bad bearing after church and found roter grinded down on inside is that a bad caliber or not ,put new roter on . I also noticed tran fluid leak not at rad fitting , but looks like maybe undr moter there are no fittings there ?? right

 

[hiboom]

without knowing what what your iac numbers are your kind of flying blind and just guessing do you know what chip your running if i had to do something with no other information i would disconnect the battery for a few minutes reconnect and let the computer relearn see if that helps.sounds like a tip in stumble taking off when letting off and dieing i'm not sure but if you fix one issue the other is probably related

 

[NY_GN]

Stall Could be vac leak, does it happen when you come to a sudden stop? Make sure the transmission line is not rubbing against the downpipe. That happened to me and it wore a hole in the trans line, started spitting trans fluid all over.