I meed an on center measurement of a B&M trans lever

[BlackBandit]

I have a B&M prostick shifter but I don't have the lever that comes with it to replace the factory lever on the transmission that the cable attaches to. I was wondering if anyone could give me the on center measurement from the trans hole to the hole where the cable attaches (for the prostick) so that I can build my own. Thanks. james

 

[BlackBandit]

Anyone?

 

[SSedan64]

Bracket Dimentions

What type Trans are you using? If your using a GM Trans the length from the (center of the Shaft to center of Cable hole is 1.9" ) and the Cable hole is 1" forward of the Shaft centerline. The Rectangle Shaft hole is .508 X .334 and is turned to the left about 20 Degrees. Tried to draw a Pic but it turned out screwed.

 

[BlackBandit]

I have a 200-4r. Thanks for those measurements. I got the shifter used with no brackets so I figured it might be easiest just to fab my own bracket that still activates all the stock column stuff. I'll use those as a starting point and tweak it from there. Thanks again, james

 

[SSedan64]

Bracket Picture

I found a picture of the bracket also. The picture is upside down but it'll help. Your 4spd trans cable would hook up to the square end. 3spd hooks to the angled end. Scroll down about 4/5ths of the page to #78.
Your Welcome,

200-4R Raptor Transmission from PATC, 200-4R

 

[jmd]

I have a B&M shift lever. Just the lever. Let me know if you need it still. I am going to a stock one.

 

[BlackBandit]

That would be great. How much do you want for it? My email is boosted@mangysquirrel.com

 

[jmd]

Let me make sure I have a stock one, take a pic and get right back to you.