Innovative 74 turbo,Richmond gears

[Jeff Rand]

74 dual ball bearing turbo with approx. 40 runs (no street miles). Water cooled center section and polished compressor housing (4" in and 2.5"out). Turbine housing is 4 bolt .81a/r Q trim with a 3.5" V band. Excellent condition. $1350 shipped

Richmond 3.90 gears for an 8.5 GM rear end, very good condition. $70 shipped.
Thanks,
Jeff

 

[John Wilde]

TTT what are you going to???

 

[norbs]

Q trim or GTQ trim?

 

[Jeff Rand]

Q trim or GTQ trim?

This turbo is a Q trim.
Jeff

 

[Jeff Rand]

TTT what are you going to???

John,
I bought a 76 GTS from Otto. I ran it over the weekend at Fontana: 1.40 sixty 9.66@141mph
Jeff

 

[John Wilde]

John,
I bought a 76 GTS from Otto. I ran it over the weekend at Fontana: 1.40 sixty 9.66@141mph
Jeff

TTT Nice job man, you could have a low 9 in that bad boy.
What is the race weight?

 

[Jeff Rand]

TTT Nice job man, you could have a low 9 in that bad boy.
What is the race weight?

Good question. I have fiberglass front and rear bumpers, no A/C, roll bar and the TA block. I weigh 200lbs so I figure about 3650lbs.
Jeff

 

[John Wilde]

942 FWHP and 799RWHP Tested from this unit.

 

[Intercooled88s]

How many miles on the gears and do they have any problems?

 

[Jeff Rand]

How many miles on the gears and do they have any problems?

I would say they only have about 5000 miles on them. When I changed my setup and dedicated the car to only racing, I change to 3.42's.
Jeff