Intake wont fit after head job

[ThikStik]

How much was it to mill? It seems like it would be difficult to cut an intake, i dont know how they keep the correct angle or jig it up. And not being a Chevy should make them mad to start with. Sorry guys , but i get burned over and over.
Looks like TA sells some .016 gaskets so ill be trying them, but they dont have the vallep pan . I dont know what is supposed to happen when not running the big valley pan, i guess it causes PCV problem with aspirating oil and could heat intake floor.

 

[SHADOWII]

Error

Shadow, not sure who your referring to, a certain machinist here on website?
Or do you mean that it will have to be a TR familiar machinist?

Sorry ThikStik, I was referring for you to send the manifold to Scott Atk to give to his machinist, but I erased part of the message by mistake.:redface:

 

[SNOWBIRD]

TA also sells a .031 as i believe .016 could be to thin ,,if you look on page 190 of the TA SITE it will explain how to fix your pcv drawing oil problem...