Lambda on PL

[TLI]

Is there a way to switch the display lambda on the PL? I am running E-85 and would rather use lambda #'s instead of trying to convert the gas a/f to E-85a/f and making a mistake and running lean.

Thanks

 

[TurboBob]

not currently, but you could connect the wideband to analog 4 or 5 and scale it however you want.

B

 

[TurboBob]

but everyone on here tends to talk about e85, and tune with gasoline scaled numbers.

B

 

[TLI]

but everyone on here tends to talk about e85, and tune with gasoline scaled numbers.

B

This is true. So if there possibly a later upgrade for the PL to read lambda? I guess it is all a conversion off of the lambda # anyway.

 

[TurboBob]

making the PLC software read lambda is not too hard, making the Scanmaster read lambda takes a bit more work.

What wideband are you running?

Bob

 

[TLI]

AEM (guage type) from Eric Marshall. I do not have the scanmaster though.

 

[TurboBob]

is it reading Lambda or AFR?

B

 

[TLI]

It can be switched between gas AFR or Lambda. I have it in the down pipe on the work bench now so it is not back in the car now.