lc1 a/f not reading on logger what and where can i get lm programmer

[bttwracing86T]

anyone can tell me where to find it my a/f is not working or reading but all is hooked up instructions say program with lm programmer3.19 please help

 

[Nigel]

You have two out puts on the LC-1, number one default is narrow band simulation, number two default is wideband. Number two should work if all else is correct.

 

[bttwracing86T]

its reading 7.36 all the time eric marshall sent me instructions but it mentions a lm programmer where do i find that

 

[Nigel]

I received a CD with the LC-1, did you buy new or used.

 

[bttwracing86T]

i bought a car with it already on it

 

[Nigel]

try here, http://www.innovatemotorsports.com/support.php you will also need the correct cable.

 

[bttwracing86T]

i got cables ive been on that si trying but im a complete idiot whenit come to computers where do i got on site

 

[Nigel]

At the top under software, try clicking the "Logworks 3.09" it includes the "LM programmer". Once installed, you will have to have the laptop plugged into the LC-1 and the key on to launch the LM programmer.

 

[bttwracing86T]

ill try that asap thanks

 

[bttwracing86T]

through usb cable or a different one

 

[bttwracing86T]

my computers jacked or something it keeps saying it failed

 

[DavzGN]

Download the install file to the desktop or copy it there. I had install problems a couple weeks ago and that's what worked finally.

Posted from the TurboBuick.Com mobile app

 

[DavidM]

my computers jacked or something it keeps saying it failed

Check your other thread.

Which software are you trying to install and what version of Windows?

 

[Nigel]

Did the install fail or did the LM programmer start to launch then fail?

The cable with mine is a serial cable then to a 1.5 mm mail jack. I have a serial to USB adapter. You have to plug it into one of the female jacks that goto the LC-1 unit. The LC-1 has to have power, so key on, then launch the LM programmer software.

 

[bttwracing86T]

ok so i got lm programmer installed and when i go to run it it says please connect device to a serial port and switch it on what does that mean. i have my serial usb cord hook to lc1 and usb into computer. please help

 

[Nigel]

You have to have the LC-1 connected to the computer and the ignition key on to power to power the LC-1. You have two female 1.5mm jacks that run to the LC-1, try one, turn ign key on, launch the LM programmer. If that does not work try the other. If you are using a serial to USB adapter you may need to install a driver for it.

 

[bttwracing86T]

key is on

 

[bttwracing86T]

i am lost on that

 

[bttwracing86T]

could you call me and maybe try and walk me through if possible

 

[bttwracing86T]

i just talked to innovate and they said to do a calibration procedure???