Motion Raceworks 2 Stage Air/Oil Separator?
- Thread starter OKTurbo
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
Pronto
No amount of evidence will ever persuade an idiot.
- Joined
- Dec 9, 2002
- Messages
- 16,768
Looks like it should work good. If you can find straight M1, I would run that rather than the orange low temp windshield washer fluid.
It’s actually Snow Performance Boost Juice….a step above washer fluid, but not by much. it’s mostly a street car and I don’t like a plastic jug of straight methanol under the hood when I’m just cruising around. The 50/50 mix is still good for detonation control. I do add a yellow container of ‘heet’ from time to time.
Pronto
No amount of evidence will ever persuade an idiot.
- Joined
- Dec 9, 2002
- Messages
- 16,768
Years ago my fuel pump popped the fuse right as I started to get into boost. I ran on alky only for about 2 seconds. It was enough to hurt a head gasket. Took all summer for it finally show it was toast but if it was less that straight M1 it would have blown right there. That's one reason I run straight M1.
The PCV upgrades seemed to have fixed the high idle BLM issue. Still need to put some more miles on it before I know for sure.
Here’s a few pics after I cleaned up the driver’s side valve cover connection. Both valve covers are teed together before the catch can, then connected to the MAF pipe.
Here’s a few pics after I cleaned up the driver’s side valve cover connection. Both valve covers are teed together before the catch can, then connected to the MAF pipe.
Attachments
Similar threads
