Need govenor spring please, and questions !

[KWIKR 1]

Guys I'm in need of a govenor spring . Any help will be welcomed . What side does it go on the small or large weight side ? And I heard one trick is to put a little dap of 5 min expoxy on the ends befroe installing to stop it from popping out again . Thanks.

 

[HOTTOGO]

http://www.tciauto.com/gm/gm_2004r.htm
It goes on the smaller one, and it's best to drill a hole and pin it with a set-screw.

 

[KWIKR 1]

it has a hole on the weight and a dimble already on the shaft . What size screw should be used ??? Thanks.

 

[HOTTOGO]

6/32" x 1/4" make sure to red loc-tite it in. Also adding that little weight may lower your WOT shift points 500 or so rpm and you may want to drill an 1/8" hole or two to compensate on either side of the screw.

 

[KWIKR 1]

Thanks for info . Now I just have to find a spring . . Getting stuff like that in Canada is a PIA .

 

[HOTTOGO]

the link above to TCI has a spring #382205 also I'm sure Bruce at PTS would have them as well.

 

[77 cruiser]

just wondering

What`s the dimenions of the GN gov. spring.
wire dia.
free length


Jim

 

[KWIKR 1]

I just ordered a spring from Bruce along with his "pressure Regulator Kit . How hard is it to install kit ? Does it come with detailed instructions ? Thanks.

 

[HOTTOGO]

Take the snap-ring out, slide the old system out and new system in, in exactly the same order as removed, install snap-ring and your done.

 

[KWIKR 1]

Nice is the bore beside the filter on the DS ? Thanks

 

[HOTTOGO]

Correct again !!!