Hey guys i have been having alot of trouble lately and im about out of funds and need some help/advice. About two weeks ago i picked my car up from storage, before storing it i had my trans rebuilt because the factory was failing. Well upon picking the car up i could tell it was shifting way to hard but i had to drive it a short distance to my home. Well about 15 minutes later the trans starts not going into higher gears so i pulled over and had it towed home. Well i got it home and pulled the trans pan and it was full of trash, i later determined that the converter failed and took the trans out with it. Well i have that all straightened out now and im just waiting on a new converter now. Well i go to change my oil yesterday and find that i have a fine mist of bearing material in my oil. Engine has about 250 miles on it, it was rebuilt 2 years ago due to main bearing failure, but only driven a little before putting it in storage. I had changed the oil twice before putting it in storage and dont remember seeing any bearing material then. Anyways i pulled the pan tonight and got a couple pictures. I have not checked rod bearings yet, but the other crank bearings are just now starting to wear. Here are some pictures i will ad more tomorrow.