You can type here any text you want

New turbo HELP!!!

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

Cbring

Member
Joined
Oct 3, 2010
Messages
146
I rebuilt my stock turbo and it blew the oil seals. It is 25 years old and didnt hold up. WELL, time for a new one. I do plan on adding meth injection soon as well Any suggestions with my setup listed below:
I have added hot wire kit from gbody parts and walbro fuel pump and turbo tweak chip and injector combo.

Things done to motor:
Comp cams
*Camshaft-212/212
*Lifters
*Pushrods
*Double roller timing chain
*Valve locks
*Valve spring retainers
Water pump
Chromoly piston rings
Speed pro .30 forged pistons
Rods reconditioned turned .10
Crankshaft reconditioned turned .10*
Speed pro bearings
Oil pressure switch
Fan switch
Coolant temp sensor
Fel-pro gaskets full set*
Fel-pro rear main gaskets
Fel-pro valley pan gasket
Injector o-rings
Rjc power plate
Billet adjustable fuel regulator*
Inline fuel pressure gauge
Fuel filter
Fuel pump
Timing cover
High volume oil pump
A/C accumulator
A/C o-rings
Thermostat
Mr gasket radiator gauge cap*Knock sensor
Crankshaft sensor
Silicone Intercooler hoses
T-bolt Intercooler clamps
Engine torque strap*
Heater core
A/C evaporator core
A/C orifice tube
R12 retrofitted to R134
Optima battery
Starter
Camshaft position sensor * * * *Billet Breather/ oil fill
Throttle position sensor
Idle air control valve
Mass air flow sensor
Alternator*
GM battery hold down*
Air Charge Sensor
Windshield Washer reservoir
Antifreeze reservoir
New tranny filter/gasket/fluid
New A/C compressor
Turbo rebuilt-360 thrust bearing and step gap piston ring upgrade
 
I'd be interested in your stock turbo and could work out a trade. I have several turbos for sale. I'd check the oil return to be sure it's not blocked. I'd only consider a te44 with a Garrett .63 ex housing with the stock converter.
 
Back
Top