Plugging alchy hole

[SS/GN]

I have an up pipe drilled for alchy but am not ready to buy an alchy kit yet.What is a good way to plug the hole for the time being until I install a kit.I found some plastic body plugs but not sure they will hold up on the release of throttle.Thanks for the input

Kevin

 

[pacecarta]

ok what about boost ???

i put a short 5/16 bolt through it with washer and nut using loc tite

 

[TRICKSIXPA]

They do sell washers that have rubber on one side similar to the washers for the alky nozzle that goes into that hole. The hole is suppose to be 13/32" for the nozzle to fit in. A 8mm or 5/16 bolt should do the job. Or just find another downpipe used for like $10 to $15.

 

[SS/GN]

The rubber plugs go in tight,just not sure they will stay in with boost.Does anyone have a pic of a complete nozzle???I was thinking of just using a nozzle and putting a cap on the end.When the time comes to buy an alchy kit,I would just have a spare nozzle.Thanks

Kevin

 

[SuperSix]

No WAY I would plug a hole like that with that rubber plug. Weld it, use a bolt, fashion a better fix, buy a new one or something.

 

[williamsGN]

Just contact Razor and he'll sell you one, probably with a cap too.

 

[jasjamz]

Rubber hose connector like you have on the MAF tube. Slice it like a 1/2 inch wide, cut it, wrap it around the pipe and put a hose clamp arond it. 30psi and still holding!

 

[SS/GN]

Thanks guys,the reason I have to use this pipe is it is a precision SLIC and the other up pipe I bought from RJC will not work.I thought the rubber plug was a stretch so I will probably phone razor on MON.Thanks again

Kevin

 

[Blue Steel]

I plugged my achy hole one time when the doctor..........oh...........sorry ...........you said alchy hole............much appology.

Blue Steel.....'87GN(Bruce Urie)

 

[Phoneguy]

Rubber hose connector like you have on the MAF tube. Slice it like a 1/2 inch wide, cut it, wrap it around the pipe and put a hose clamp arond it. 30psi and still holding!

Great idea... I just removed my dual nozzle and have to plug 2 holes in my Cottons up pipe.

Bryan

 

[turbofabricator]

Yep, agree with a section of turbo hose. Heck you could even get by with electrical tape and a hose clamp.

 

[notacarlo]

Really? Rubber hose and clamps?

Put a nozzle back in it and screw on a cap. Or go to a good muffler shop and have it filled for $10.