Powerlogger not displaying boost currently...

[Fitman5150]

got a new laptop (Windows 8) for xmas top use solely for my GN. (IM A MAC GUY BY CHOICE)
hooked it up to car last night with PL.
at just an idle, all readings work but boost. only displays -29.5

i was using a slow ass laptop with windows 8 as well before.

any help would be greatly appreciated!
THANKS IN ADVANCE

 

[TurboBob]

your MAP sensor signal is not getting to the PL.

Did this work before? Perhaps the beige cable has come unplugged.

Bob

 

[Fitman5150]

Bob,
yes sir it worked fine before.
beige cable being the one that is plugged in to analog bar behind glove box?
thanks for your response!

 

[dank GN]

Is the reading off? If so there are offsets you can change to get the correct readings. Grounds are the major reason for offset changes . Double check your grounds then play around with the offset .

 

[TurboDave]

Is the reading off? If so there are offsets you can change to get the correct readings. Grounds are the major reason for offset changes . Double check your grounds then play around with the offset .

The reading he's getting indicates there's no signal input from the MAP

 

[Fitman5150]

Fixed.
PL board in ECM was slightly loose. Secured it with industrial duct tape.
Thanks for every ones assistance!