Scanmaster quit working

[TurboTGuy]

Like the title says. It worked a couple days ago but today, I went to drive it to work and it flashed SCN 2.2, then PL 4.8 and then went blank.

Does that every time I start the car.

I'm at a loss, here folks. Any help would be appreciated.

Thank in advance!

 

[TurboBob]

Other than checking the connections, there is a setting in the PowerLogger that changes the datastream mode. Thats what I would check first.

 

[Creven405]

Were you able to figure this out? Mine is doing the same thing

 

[SCOOBY DOO]

Guy, check the connections. Had a few do that. I hard wired them...soldered them...problems solved.

 

[TurboTGuy]

I followed Bob Bailey's advice... Installed the latest software.

I think I'm good now.


"there should be a checkbox in Scanmaster Options on the config page

your version of the PLC program may be too old. Try this one.

https://www.dropbox.com/s/3pry2lv66b4nt4w/PLC-2-6-8.zip?dl=1
Bob

--------=======|||||||=======--------
Bob Bailey"

 

[TurboTGuy]

Guy, check the connections. Had a few do that. I hard wired them...soldered them...problems solved.

BTW, I did that years ago. Still have a little melted spot in the carpet on the trans tunnel where a drop of solder hit. I dyed it, so it hardly shows...

Thank you for the suggestion, though.