Sheet Metal Trans Pan ?

[jmendlik]

Anyone ever seen this type of filter used with a custom Aluminum pan? Is this is one of PTS Extreme bottom feeder set-up?

I may purchase this pan set-up for my 200-4R trans.

Where can a new one ( Filter) be purchased ?? Got a part number on this filter?

JM

 

[INEEDAGN]

Yes and that's a mopar 727 filter.

 

[Boost231]

Yes, same setup I run

Sent from my SM-G935T using Tapatalk

 

[turbo nasty]

Looks like a old PTS setup

 

[jmendlik]

is this worth $200...on a flat surface it does rock a little so it needs to be worked on to be flat/ture

 

[INEEDAGN]

I'd say it is. You have to watch your ground clearance with it but otherwise it should be fine. The only thing that has to be flat is the gasket surface.

 

[Boost231]

Never had issues with mine omas for ground clearance.

Imop that looks similar to the one bruce sold but from the looks of it that looks like a copy.

Sent from my SM-G935T using Tapatalk

 

[Otto J]

That’s not a Mopar 727 filter. It’s a General Motors 200C filter

 

[INEEDAGN]

Well I'll be damned. I didn't look that close at the second pic I just knew most of those setups used the mopar filter. You appear to be correct sir.