TA performance alum. block?

[trading t/a]

Will the block come in different sizes? Meaning like the LS1 could you bore it out without hitting the water jacket to a 4.00in. bore? I'm currently debating on a next project if I keep her.

Wife's car died and had to lay a few grand on a new suv, so I'm thinking of trading for a new f-body as a daily driver.......(trust me it's not what I want to do...)

 

[turbota]

Who's casting a early design 3.8 block ?

 

[KIDDBOOST]

All the specifics on the TA block can be found in General Bucik Tech section

 

[Two Lane]

www.taperformance.com

 

[turbota]

Thanx for the info. As these things get older this sounds like a good "back-up plan" Thanx again, Turbota.

 

[HouseofSpeed]

Trading....the LS1 will not go 4.0 without a resleeve....stock bore is a 3.89-3.90....and the service cut allowance is only .010.

 

[trading t/a]

What I meant was, what is the bore thickness? Can it be overbored .200 to get a 4.00 in. bore with out hitiing the water jackets. Will it be like the LS1 meaning it is pretty meaty and could easily go to 4.030 with a resleeve.........