I have been hearing a lot about the new turbos, My car runs real good for what it has, Rides like a Caddy on the street and gets about 23 mpg, I would trust it to go cross country, It is a street car that I like racing it now and then, It runs 10.40 at 131 on 22 pounds of boost with the alky set on about 4 or 5 and 100-105 fuel, I don't want to turn it into a race car as it is like new, It was purchased here in town to use as a race car, He never drove the car, It had 6,000 mile on it when I got it and I think most them were burnout miles, Always in the garage with ac on it in the sumer and heat in the winter, Most that has seen it run say turn the boost up but it spins the slicks now so it would do little to help it, Now here is the problem it is just so hard to race, I know I am being picky, You have to start boosting it as you come in the lights and then bump it in boosting all the time trying to keep it at 5-8 pounds of boost, Anymore you blow the tires off and less you don't run as good and hard on everything, What I would like is a turbo that boost as quick as it can and maybe even pick up a lttle, Here is my build, I have to change the fuel pump as it doesn't work to good at 130+
1987 grand national
3.8
30 over JE Pistons/ Total seal filed rings
Eagle H rods
Eagle balanced crank
Girdle
Champion aluminum heads
Champion flow matched intake
1.65 Shaft Mount roller rockers
Comp #69-400-8 218/112 Cam
Hemco plenum
Accufab 70mm throttle body
Big Front mount Intercooler/ 2 1/2 pipe
83lb high impedence injectors
Walbro pump,hot wired
200 4r with all the good parts
ptc 9.5" convertor,5 disk lockup/Locks at 126 mph
3.42 gear
LT1 mass air meter with translator
4" cold air intake
66BB turbo
TA performance headers
ATR 3" down pipe
Turbonetics delta gate mark II 6psi
Turbonetics boost controller
Alky Spray Kit
1987 grand national
3.8
30 over JE Pistons/ Total seal filed rings
Eagle H rods
Eagle balanced crank
Girdle
Champion aluminum heads
Champion flow matched intake
1.65 Shaft Mount roller rockers
Comp #69-400-8 218/112 Cam
Hemco plenum
Accufab 70mm throttle body
Big Front mount Intercooler/ 2 1/2 pipe
83lb high impedence injectors
Walbro pump,hot wired
200 4r with all the good parts
ptc 9.5" convertor,5 disk lockup/Locks at 126 mph
3.42 gear
LT1 mass air meter with translator
4" cold air intake
66BB turbo
TA performance headers
ATR 3" down pipe
Turbonetics delta gate mark II 6psi
Turbonetics boost controller
Alky Spray Kit