Chevman2448
Member
- Joined
- Nov 15, 2013
Not sure if this is the right place but...Are AN lines that difficult to assemble? I bought a -8 feed line and everything went right together. THis -6 line has been a royal pita. Put the brass piece in there so the the inner PTFE line was flush and slid the fitting into the line. I went to slide the nut up and over the brass crush sleeve and the nut wont even go over the crush sleeve?
![](/proxy.php?image=http%3A%2F%2Fi1041.photobucket.com%2Falbums%2Fb413%2Fchevman24%2F2014-06-19_21-06-42_128_zpsb7bfe225.jpg&hash=31b18adbb58b5a8d7e57e881a4f1fdaa)
![](/proxy.php?image=http%3A%2F%2Fi1041.photobucket.com%2Falbums%2Fb413%2Fchevman24%2F2014-06-19_21-06-26_654_zps9367c3ef.jpg&hash=1991f68bbd9e281ab626e1110fdd566e)
![](/proxy.php?image=http%3A%2F%2Fi1041.photobucket.com%2Falbums%2Fb413%2Fchevman24%2F2014-06-19_21-06-42_128_zpsb7bfe225.jpg&hash=31b18adbb58b5a8d7e57e881a4f1fdaa)
![2014-06-19_21-06-42_128_zpsb7bfe225.jpg](/proxy.php?image=http%3A%2F%2F%5BURL%3Dhttp%3A%2F%2Fs1041.photobucket.com%2Fuser%2Fchevman24%2Fmedia%2F2014-06-19_21-06-42_128_zpsb7bfe225.jpg.html%5D%5BIMG%5Dhttp%3A%2F%2Fi1041.photobucket.com%2Falbums%2Fb413%2Fchevman24%2F2014-06-19_21-06-42_128_zpsb7bfe225.jpg&hash=9ab3dfc11b849d4db776d008e6abe59c)
![](/proxy.php?image=http%3A%2F%2Fi1041.photobucket.com%2Falbums%2Fb413%2Fchevman24%2F2014-06-19_21-06-26_654_zps9367c3ef.jpg&hash=1991f68bbd9e281ab626e1110fdd566e)