9" 3rd member/Moser wavetrac

[6togo]

I have a brand new never used Yukon aluminum thru-bolted 3rd member with large bearing 10 bolt daytona pinion support, 3.50 motive perf. gears, 35 spline Moser Wavetrac posi (lifetime warranty) ,Billet 1350 yoke, and all timkin bearings prof. setup ready to install. It is a very stout unit and should handle some big Hp! I am going another route that is why i am selling i paid $2000 +shipping will sell for $1700 +shipping or if in the general are can meet! Here is the details when i ordered the unit=
- Yukon Aluminum Thru-Bolt Case (3.25)
- Aluminum 10-Bolt Daytona Pinion Support
- 1350 Billet Steel Yoke
- Motive Performance Gears (3.50 Ratio)
- Moser Wave-Trac Unit - 35 Spline
- Timken USA Bearings
The Wavetrac cost $1000 alone!

 

[TR Custom Parts]

Drool!

 

[6togo]

 

[jdpolzin]

Thats a nice piece! I love my Wavetrac! You should also mention that the Wavetrac has a lifetime warranty!!!!

 

[6togo]

Thanks Jeremy i did slide the lifetime warranty in the post but i am one of those guys that jambs everything together so its not real easy to see!

 

[jdpolzin]

No prob! I'll be the first to say that this particluar center section is unlike any other center section available in the market. This is the best of the best. It is garaunteed to handle power in the 1000+HP level and drives like a normal stock posi rear end. There is no better 9" center on the market. Good luck with the sale brotha!

 

[6togo]

Evening Bump!

 

[6togo]

$1700 Shipped?

 

[6togo]

Bump!

 

[dvernst]

If only it had 3.23 gears...

 

[6togo]

I heard this many times so far gears for the 9" are fairly cheap ($200)and changing them is easy that is what makes them nice. Some guys keep multiple sets of gears to fine tune depending on the tire they run. I went with this size being it was as close to the factory 3.42 i could get and when running a drag tire most are taller anyways lowering the ratio!

 

[6togo]

TTT!

 

[6togo]

Back up!

 

[6togo]

Morning bump!

 

[6togo]

Offers???

 

[6togo]

Anyone?

 

[dvernst]

Just swapping gears isn't too hard, but getting them set up properly, so there is no noise is where you need to have experience. I wish I could have bought your center section, but I needed a 31 spline posi, and a 3.25 ratio... This thread did inspire me to get the Wavetrac, and I finally have everything ready to install, and should have my car back on the road by this weekend. The 31 spline Wavetrac is on sale for $210 off also.. If you didn't sell this yet good luck!!!

 

[6togo]

Yes it sold a while back it is a very nice unit though to bad they dont make a 40 spline version!