Help!!!!!

[figga8n]

installed razor kit getting 5 volts from 3 bar map and 5 volts from top of tps( gps enhancer)! I have a cyberdyne dash (stock was analog)Were can I connect the green wire to get the 1.5 volts

 

[QUIP'6']

http://www.turbobuick.com/forums/alcohol-nitrous-propane-tech/211821-3-bar-map-digital-dash.html

 

[figga8n]

http://www.turbobuick.com/forums/alcohol-nitrous-propane-tech/211821-3-bar-map-digital-dash.html

ok im not the sharpest knife in the drawer!!! i read it but cant understand it without the pics:redface: can someone please walk me through this i use to have a smc kit and the install was as simple as abc, but the outcome wasnt what i expected i jumped the tos wire to the 3 bar map wire and the tps ground to the 3 bar map ground and still getting 5 volts i cant figure this install out i have a cyberdyne dash and this is wearing me out besides all the other problems im having with the car

 

[pacecarta]

sent you an email and some pics

razors instructions with the alky kit are very clear on how to connect the map and where to connect the map output , in your case just follow directions for gnx /digital dash cars

when you finally have it wired be sure to verify 1.6v at the green wire at the PAC controller (key on engine off) so that you can be sure that ant connections you made to get to the PAC are good

 

[Razor]

sent you an email and some pics

razors instructions with the alky kit are very clear on how to connect the map and where to connect the map output , in your case just follow directions for gnx /digital dash cars

when you finally have it wired be sure to verify 1.6v at the green wire at the PAC controller (key on engine off) so that you can be sure that ant connections you made to get to the PAC are good

Thanks Paul..

Julio

 

[figga8n]

ok fix that problem it was the PAC ground:redface: now I only get a beeping sound from pump when I hit the test button

 

[Phoneguy]

I think you should remove the Cyberdyne and and re-install the analog then mail the Cyberdyne to me:biggrin:

Bryan

 

[figga8n]

I think you should remove the Cyberdyne and and re-install the analog then mail the Cyberdyne to me:biggrin:

Bryan

I'm would of gave it to you if I thought that would keep me from running alky:tongue:

 

[Phoneguy]

You are just a little frustrated right now. You will LOVE Julios ALKY kit.

Bryan

 

[Razor]

ok fix that problem it was the PAC ground:redface: now I only get a beeping sound from pump when I hit the test button

Thats normal. BEFORE putting alky in the tank.. make sure the LED's are working normally.

The low level is ON, the TURNON is red when you hit the TEST and off when you dont.. If this is passed..

Put liquid in the tank, check for leaks.. turn the Gain knob to "8".. start car.. let the engine idle.. now press and hold the TEST button.. a few seconds latter, motor should stumble..

If so.. time to drive car and see if it activates under boost. I preset to come at 6-7 PI boost.

It should if the MAP sensor was wired correctly and it has a vacuum/boost signal on its nipple.