Inner Wheel Houses L and R

[TurboWh1]

I'm working on replacing quarters on a project car I picked up and it needs a portion of the wheel house on each side. I can buy new aftermarket but too rich for my blood. I thought Id see what was out there before I start fabricating my own. I really need the section that welds to the floor. (typical rust area) Very close to the frame rail.

 

[Toby_Goodmk]

I created those wheel houses, I am sorry they are quite expensive, as the tooling is expensive and needed to amortized through a few hundred runs. What in your opinion is affordable? I will say they are rock solid nice. I have the test sample that I used on an entire quarter cut from a car and the quality is worth some expense.

 

[TurboWh1]

I created those wheel houses, I am sorry they are quite expensive, as the tooling is expensive and needed to amortized through a few hundred runs. What in your opinion is affordable? I will say they are rock solid nice. I have the test sample that I used on an entire quarter cut from a car and the quality is worth some expense.

I was hoping to find something in the neighbourhood of $100. I can fabricate if I need to. I really don’t want to put in the entire inner wheel house as there is more structural work to do. I have a pair of used quarters but the inners need some patching. Just figured if I could find something reasonable I would spring for that. My used outers are in excellent shape so buying a new complete pair just doesn’t make any sense to me. Nice job on the workmanship tho! They look spot on from what I could tell on gbodyparts and goodmark.com

 

[Toby_Goodmk]

sounds good, good luck with your repair!

 

[TurboWh1]

sounds good, good luck with your repair!

Thanks! It will probably be the cheaper route for me. Just some time and several beers in the garage