MAF Pro connected, Now shooting out codes

[GNguy]

Hey Guys, Well I just got done installing the MAF Pro but now it is shooting out a code 34 and 23. I have the MAF sensor unplugged but I am running it without the MAF option....Any Ideas?? thanks

 

[PaCemkr86]

what chip are you using?
when you turned it on did the maft pro recoginze that its set up for mafless?

 

[GNguy]

Erics

 

[PaCemkr86]

the ones i have installed have all been with the maft pro chip from Full Throttle and have installed with out any problems. Maybe Bob Bailey can shed some light here

 

[GNguy]

Ok, I get my Pro chip tommorow or the next day so I guess I will run with it for right now. I hope it works with the chip......

 

[PaCemkr86]

Im sure it will.. post up if it doesnt, ill see what i can do to help ya

 

[GNguy]

Well I connected the MAF and I am still getting the same codes.....

 

[FastRegalWE2]

also you can try www.fullthrottletech.com
you might get an answer there or search the site

 

[DonnieShort]

More than likley one of the set up page settings are either off or a mixed up wire, just small stuff. When you get it lined out you'll love it!! Good Luck, email me if you need any help or have questions.

 

[GNguy]

It still shooting out codes......any one have ANY idea??thanks

 

[Mike Licht]

Check the thread on www.fullthrottletech.com.
We cannot support them here and there to confusing
Mike

 

[PaCemkr86]

did u get your pro chip installed?

 

[Mike Licht]

Shows signs of a wiring problem, a chip will not fix this
Mike