Need to tap and place a fitting on a plastic washer reservoir tank?

[2QUIK6]

Is there a good place online that sells various fittings to do this?
I'm going to convert my washer fluid bottle to hold my methanol / water mix for my truck and will need to tap a line into it, then get a tiny bottle for the washer fluid and tap a small hole in it for the pump inlet.
Is there a place that sells various fittings and seals for this?

 

[jpwalt1987]

McMaster Carr has all that stuff

 

[charlief1]

You could also to to AZ and look at the aftermarket puke tanks Rob. They've got a large and small one so you can have the capacity you want without having to loose the washer tank.

 

[2QUIK6]

McMaster Carr, didn't think to look there, I will later this eve, I've bought a crap load of stuff from there for my old business.

Charlie, the washer bottle is perfect because it already has the low fluid sensor and all, will just need to make the inlet hole a little bigger for the meth pump intake line.
Need a small little bottle to make the new washer fluid bottle which the pump inlet is directly on the side of the bottle, I'm hoping the factory gromet will work for this and seal correctly...may buy a new washer bottle and a new gromet in case I screw up The factory washer bottle is HUGE on this truck, so it will hold plenty of boost juice!