Original SD2 tune file

[TurboBuRick]

There is currently no way to load the original tune file if it was not saved.
That said I'm looking for the original tune file before any changes were made to the ve table.

TIA

 

[dank GN]

It is stored in the chip

 

[BEATAV8]

There is currently no way to load the original tune file if it was not saved.
That said I'm looking for the original tune file before any changes were made to the ve table.

TIA

attached

 

[TurboBuRick]

It is stored in the chip View attachment 302115

Unfortunately the ve table values are not stored.

 

[TurboBuRick]

attached

Thank you Steve!

 

[BEATAV8]

I just remembered that BIN file is probably from the original rev 1.1 SD2 chip, before the flex-fuel stuff was added with rev 1.2

not sure if that will matter at all, just be aware.

 

[BEATAV8]

Yeah, looking at the ethanol percent and e85 spark adder you can see there's some gobbly-gook in there..... it's just old that's all.

 

[TurboBob]

the base tables are part of the flash image, so just re-update the powerlogger to restore them

 

[TurboDave]

It is stored in the chip View attachment 302115

But notice it says it does not affect the ve table, etc.


Sent from my iPhone using Tapatalk

 

[dank GN]

But notice it says it does not affect the ve table, etc.


Okay I was under the impression that 1 didn't reset the be table but 2 reset it . I'm most likely wrong but that's what I was under the impression of

 

[jasjamz]

Made a blunder here in the spark and ve tables. How do I make them (the Spark and VE tables) go back to default?
Do I reflash?

 

[TurboBuRick]

Bob says reflash will do it. I have not had a chance to try it. Lmk of it works.

 

[Eric Stage I]

I will dig out the original tune (.bin) file tonight and post it.

 

[TurboBuRick]

I will dig out the original tune (.bin) file tonight and post it.

Did you have a chance to dig it up?

TIA

 

[Eric Stage I]

Ran out of time last night. I'll try again tonight.

 

[Eric Stage I]

I added the default tune file to my support forum, www.turbotweak.com/forum . In the SD2 section, it's a sticky at the top.