After sanding the bottom side of the 86 and knocking off 50 lbs of rust and stuff i final cleaned everything w/ laquer thinner and shot it w/ por 15. It workd great on the steel that was rusty, but on the bare clean steel it didnt stick. It pulled off in sheets. I really didnt wanna go the route POR sugests w/ useing a water rinsed etching fluid since they say POR 15 is so sensitive to water.
I got a quart of self etching primer, ( w/ zink chromate), and shot the bare steel spots w/ that, and then the POR 15. Checked it this morning, so far everything looks great, but its not dry yet Its in a heated garage and the last time it dryed fully overnite. Hmmmmm.....
I cut it w/ laquer thinner so i could spray it, waited over an hr for the self etching to dry. I wonder whats up
So far so good tho, it looks like a million buks
Hmmmmmm, 1m on EBay ??
I got a quart of self etching primer, ( w/ zink chromate), and shot the bare steel spots w/ that, and then the POR 15. Checked it this morning, so far everything looks great, but its not dry yet Its in a heated garage and the last time it dryed fully overnite. Hmmmmm.....
I cut it w/ laquer thinner so i could spray it, waited over an hr for the self etching to dry. I wonder whats up
So far so good tho, it looks like a million buks
Hmmmmmm, 1m on EBay ??