Scanmaster G - Cannot Monitor Boost on Gauge

OvaBoost

Quick Brick
May 16, 2011
158
4
18
Long Island, New York
@TurboBob

Finally got my Buick build complete.

Whenever I try to monitor boost on the Scanmaster G , the display quickly switches to Alcohol content. I am currently not using Alky.

Flashed my SMG to B_1_06.S19 - Still switching to Alcohol
PLC ver - 2.6.8.49

Any ideas?
 

TurboBob

Resident mad scientist
Staff member
May 24, 2001
6,136
455
83
Commerce Township, Michigan
notifications from the board are not working, I just stumbled upon this thread.

email me at bob AT bailey-eng DOT com, we can figure it out. The alcohol display should not appear unless the PLC is reading alcohol, which is shouldn't be. What chip are you running?

Bob
 

OvaBoost

Quick Brick
May 16, 2011
158
4
18
Long Island, New York
notifications from the board are not working, I just stumbled upon this thread.

email me at bob AT bailey-eng DOT com, we can figure it out. The alcohol display should not appear unless the PLC is reading alcohol, which is shouldn't be. What chip are you running?

Bob
Thanks Bob! Sent info to your email.