Scorpion P/N SCC-SPC1048BL

[Bill_Ritter]

I need a set of Scorpion rockers for 14 bolt aluminum GN-1 Heads. The set I have cracked at the tips by the roller pin. (so I already have the studs and push rod guides)

Will the SCC-SPC1048BL Rockers fit the GN1 14 bolt head?

Here's the link for reference. http://www.summitracing.com/parts/scc-spc1048bl/overview/ They are listed to fit 3.8L v6.

There is also another part # that is listed to fit 4.3L v6 http://www.summitracing.com/parts/scc-scp1094bl/overview/ but I dont see any differences listed when you compare the specs. I'm sure there is though.

Any help would be appreciated, I need these ASAP if they'll work!

 

[earlbrown]

I was thinking those used SBC rockers. The 4.3 chevy might be the same thing.

 

[Bill_Ritter]

I heard that as well, MANY years ago but never verified if it was accurate or not. I may just order both sets and see which ones work, since I have correct ones here to match them up against.

 

[KevinB]

You already have the studs and guide plates at least

Posted from the TurboBuick.Com mobile app

 

[jmendlik]

Weber Racing

http://www.weberpowerproducts.com/scorpion-1-65-turbo-buick-v6-roller-rocker-arms-p/spn-scp1049.htm

 

[Team Banana]

We went through this and end up getting them from Weber. Part # spc1093bl. I don't think the ones your talking about have the offset needed. I may be wrong

 

[Bill_Ritter]

Edit: The 1094's are listed as having a ratio of 1.55/1.65, is that an "either/or" or is it a set of mixed ratios for exhaust and intake? Now i'm just curious haha

I need 1.55 ratio arms

I'll call webber today.

 

[Team Banana]

I might have some used ones that you can have. We had a couple that the needles fell out of. I will see what ratio they are if you want them

 

[Bill_Ritter]

If they're 1.55 id be interested for sure!

Posted from the TurboBuick.Com mobile app

 

[earlbrown]

When doing a search at summit for SBC rockers, there's a checkbox for 'offset'

 

[Team Banana]

The ones I have are 1.6. You might be able to get a trunion kit for these cheaper than a complete set of rocker. Like I said, they just had some needles fall out of the trunion. Just throwing it out there

 

[Bill_Ritter]

The ones I have are 1.6. You might be able to get a trunion kit for these cheaper than a complete set of rocker. Like I said, they just had some needles fall out of the trunion. Just throwing it out there

I bit the bullet and ordered a set, But Kevin B. will probably take those off your hands. I found a Buick vendor with them sitting on the shelf, Shipped out today.

 

[Team Banana]

I was going to say that you might have been able to put your trunions in these rocker. Don't throw yours away

 

[Bill_Ritter]

I didn't even think of that.

Posted from the TurboBuick.Com mobile app