TR Custom Parts - We are still here..............................

[TR Custom Parts]

Our banner ad has not run for quite a while now as well as other sponsors of the board. Just a reminder that we are still here supporting the board and waiting for your orders! Click on the banner below to go to our site. Long time members know about us but want to let newbies know we are here.

Support the other board vendors as well by going to this page......... Supporting Vendors

I know that there is a lot going on behind the scenes with upgrades to the board and hopefully banners will be back up soon.

 

["Reaper"]

Just ordered a LICENSE PLATE FRAME hope I did it right. Got the mustang one.
I want black frame with red letters. replace 12 with 10.5 Will adding the .5 make it to jumble? if so just do 10

Thanks you have lots of cool stuff.I love my shifter handle to by the way.s
Shaun

P.S. I love my shifter handle to by the way.I got one of your last runs.Do you have any coming up again I have some friends that want one?They think mine is bad ass.:biggrin:

 

[SGRIM]

Mark is a great vendor, thanks for you contribution to the community Mark!

 

[we4Mateo]

Mark is a great vendor, thanks for you contribution to the community Mark!

x2

 

[gnxtc2]

Mark is a great vendor, thanks for you contribution to the community Mark!

x3

Billy T.
gnxtc2@aol.com

 

[TurboTnZ06]

Mark is a great vendor, thanks for you contribution to the community Mark!

x4 He resent a custom uppipe with an inch on each end extra to fit my setup better!

 

[Pronto]

I hope the banner issues can be resolved for you when the new board gets up.

 

[TR Custom Parts]

zzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzz

 

[BobbyBuick]

Hey Mark Thanks for the quick shipping got it and it is PERFECT!!!!!!!!

 

[RobsIron]

Mark has always been my go to guy. Wish my car needed more stuff.

 

[ttaowner]

mark is a great guy we get to hang out at local swap meets and our local hang out spot. i still have those parts here for you since last fall so when ever you want to pick them up there still here

 

[TR Custom Parts]

Hey James, will make it up there one of these days.

 

[TR Custom Parts]

Check out this speedo panel my engraver did. This went into a Riviera, uses overlay as our cars.

 

[JOHNDEEREGN]

:biggrin:Whos Mark :biggrin:

 

[SuperCPA]

I recently finished wet sanding, buffing and polishing out this nice vac block that Mark sells. Even without this extra step it still comes with a nice milled finish. I am looking forward to not having any more vac line blow offs.

 

[JayC]

Thats a nice looking part.

 

["Reaper"]

Got my Plate Frame in and love it. It has already PISSED OFF a mustang guy!

 

[SuperCPA]

Got my Plate Frame in and love it. It has already PISSED OFF a mustang guy!

HA! Nice!