Tr6 issue

[NY_GN]

Can you confirm feed voltage to the cam sensor?

I did last night, so it seems the coil pack is the likely suspect now. Only thing I can't figure out is why the TR6 is throwing code for cam sensor.

I'm tracing wires in the engine harness now, don't make sense to slap new coil pack if I have a bad grnd or pinched wire somewhere.

 

[Jerryl]

If I understand:
Every time you put another cam sensor cap on, the car ran fine?

 

[NY_GN]

If I understand:
Every time you put another cam sensor cap on, the car ran fine?

Prior to this issue, yes, but now with known good caps it will not run at all.

The CCCI Fuse keeps blowing, when I replace it, the car fires up but sounds like only 3 cylinders. It will run for 10 seconds, then it blows the fuse and stalls.

Gonna recheck all grounds, the fuse box and regap the plugs, then see where I'm at.

At this point it doesn't seem to be an issue with the TR6.

 

[TurboBob]

We should make sure your TR6 is up to date also.

Bob

 

[NY_GN]

We should make sure your TR6 is up to date also.

Bob

I agree, what version is the latest and what is the procedure to update.

 

[TurboBob]

2.1 is the latest. You can see the version by turning on Mode 2 while the key is on.

Updating is pretty straightforward with a laptop and USB cable.