Forced Induction's FI91X report!

[JZ 97 SS 1500]

Jose,
Silly question...Is there a unit between the 91 and the 98? How much are these units..

Louie as Dusty said, we have the 94 available now.

 

[JZ 97 SS 1500]

The car is already setup for a set I have stored in the shop. I think you're right. I'd better dust them off and have them on the car until I can see what this is going to be like.

I didn't see any nitrous being used. That thing spooled up pretty decent.

That car uses NO nitrous, since the class they run does not allow it. The turbo spools very nicely indeed.

 

[Alky V6]

That's exactly what I'm hoping for with the ETT wheel.

 

[Alky V6]

OK... I'm pumped. Time to go to the shop and get something done on the car.

 

[XxDarkSidexX]

ty for the link to the other board, the c02 for boost controll was a first time read for me. very interesting!

Don dont forget some pictures real quick when your done today!
XxDarkSidexX

 

[Alky V6]

ty for the link to the other board, the c02 for boost controll was a first time read for me. very interesting!

Don dont forget some pictures real quick when your done today!
XxDarkSidexX

Tomorrow I should have the aftercooler to throttle body piping finished. I'll get some new pics then.

The adapter flange was a walk in the park compared to the plumbing.

 

[Scott89TTA]

The Trans Am with the FI98X was at our local Home Depot cruise night this past Saturday...that is one hell of a setup. The owners are form a local sop in Finksburg MD Performance Auto Fabrication about 10 minutes from me.

Here's a couple pic's...

 

[JZ 97 SS 1500]

Sick pictures.....that 98X is working well for him. He's making over 1000rwhp at only 20psi and a small 366 LS1 motor. It will be fun to watch when he's in the 30psi range.

 

[Alky V6]

All that's left is the compressor inlet housing.

 

[Alky V6]

Up pipe.

 

[Alky V6]

Not much room for the inlet box, but I'll figure out something.

 

[Otto J]

Damn,You didnt mention you had no exhaust and an air-t0-water intercooler also!

Looks great Don

 

[Alky V6]

Thanks Otto.

Race cars don't need exhaust.

 

[Alky V6]

I have a bracket supporting the up pipe at this point.

 

[Chevota]

Beautiful.

 

[Alky V6]

Here's the adapted turbo hanger/boost control solenoids bracket. I tested it by unbolting the turbo from the exhaust flange. I needed to seal the flange adapter for final assembly. The hanger looks flimsy, but it held the weight just fine while I sealed the flange adapter. The vacuum hoses have since been tie wrapped.

 

[Alky V6]

Thanks Scott.

 

[Alky V6]

More misc. pics.

 

[Jerryl]

One word;

SICK!

Oh yeah, NICE fabbing!

 

[1dmbth]

LOOKS GREAT. Look foward to see what it will be running.