Going to the dyno

[Sweet6]

I finally got my Razor Alky kit put on. I wanted to ask a general question about what to adjust the dash controller to. I have a basic setup. Stock longblock, 50lb injectors, 61BB T-netics, TT chip. I have the FP at 40PSI and the controller at 4.5 or so. The car seems to run well with that. I know it is on the rich side. But not bad. Boost is about 19-20lbs. I should have about 23-24lbs on the dyno. Does 40PSi and 4.5 on the controller sound about right? I am just looking for some guidance from guys with similar setups or experience.

 

[Razor]

Fuel pressure is set by looking at BLM's. If you need less fuel, pull it out of the chip programming it. Your knob setting is fine. I'd tell you more is better than too little. Start the knob on 5-6 and work your way from there.

Read this,
http://www.turbobuick.com/forums/alcohol-nitrous-propane-tech/147348-tuning-alkycontrol-kit.html

HTH