Of course....Here is the carnage...
note the pic of the cyl#2. that sleeve like metal. Do I need to machine it down, remove it, etc, to use the RJC headgasket?
The head does NOT have a matching recessed area.
The engine had Felpro headgaskets.
Also, do I need to rehone the cylinders, note the scratching. There is some rust on the lower part on some of the cylinders. Can I sand it down or use a honing tool (which one?)
also, note the rod bearings.
I plan to change them anyway but are they ok?
Keep in mind that I ran the engine at idle with oil and water mix for like 15 to 20 minutes.