Is this a good combo?

[Machran]

Looking at this as a street strip combo. Owner says 20 psi around 500 hp.

109 block .30 over, no girdle, stock rods and crank
te 45a
4 steel mains
Weber heads and intake
72 lb inj
accufab plenum with 70mm TB
PTE frony mount
ATR headers
206-206 billet roller with T&D 1.65s
3" DP
single 340 Walbro
ls1 mas air
turbo tweek chip
Any help would be greatly appreciated.

 

[jasjamz]

sounds right... Flywheel horsepower that is...

 

[Machran]

What I`m asking is, are these parts matched well?

 

[87Gnastey]

What are you running for pistons?

 

[Fachie Motion]

Just buy the thing , I would if I had the $$$$ just for the looks :biggrin:
Everything sounds right but I don't know much about Weber heads.
Good luck.

 

[Machran]

Je pistons.

 

[87Gnastey]

Sounds like a pretty sweet set up.

I believe there was a previous post about the HP limit on stock cranks. I'm sure there are some cases where people get a ridiculous amount of Hp out of a stock crank but for the most part I thought they were only good for around 500-550hp.

With that being said I guess don't cheap out on the bearings.

 

[1of1547]

What part of Maryland are you from?

 

[Machran]

I live in havre de grace now.

 

[BIGPSI]

my combo is very similar and i love it. i just need to get it fine tuned and a good 60 ft and i should easily see low 11's high 10's